RTC125 relay tester specifications

Physical format
PC104 compatable; 4.1 in. by 6.0 in.
I/O Connectors:
37-pin RUT
4-pin coil power input
10-pin accessory
Power requirements:
+5VDC, +12VDC, -12VDC

Tests
Pull-in/Drop Out Voltage (ramp or step)
Pull-in/Drop Out Current (ramp or step)
Operate / Release Time
Contact Bounce Time
Contact Resistance / Voltage Drop
Contact Stabilization Time
Coil Resistance
Coil Current
Induced Coil EMF
Time Delay Operate / Release
Dielectric Withstanding Voltage1
Insulation Resistance1

Programmable Test Conditions
Coil Voltage
Coil Current
Coil Ramp Rat / Step Rate
Coil Current Soak Time
Contact Configuration (4PDT expandable to 8PDT)
Contact Load Level
Contact Load Current1
Contact Settling Time
Dielectric Test Voltage1
Dielectric Test Dwell Time

Measurement Ranges2
Coil Voltage 0 to 80.00VDC
0 to 240VAC1
Coil Current 0 to 800.0 MADC
Oper. / Rel.Time 0 to 163.83 MS
Bounce Time 0 to 163.83 MS
Time Delay 0 to 65.534 S
Contact Voltage Drop 0 to 80.00 MV
Contact Resistance3 0 to 3.000 Ohms
1. Parameters supported by optional expansion modules.
2.Accuracy on all measurements is ±0.5% of measured
value ±1 LSB.
3.The internal contact load is 10 MA/30 MV open
circuit